您好,接待惠临威尼斯注册送200官方网站!

你地点地位: 首页 >> 消息资讯 > 公司消息 >
公司消息

打金鱼 的宁静支配应当注重甚么?

来历:http://zhaoyanfilter.com/ 时候:2021-05-17

(1)打金鱼 起头任务前,起首策动汽车策念头运转半晌,向贮气筒充气;
(1) Before the mixer starts to work, first start the engine to run for a while and inflate the air reservoir;
(2)把支配油泵伺服阀的手柄放在中间地位(此时搅拌筒处于运动为止),支配油门手柄把油门开到30%的开度,再支配伺服阀手柄,使拌筒在2r/min的低速下正转;
(2) Put the handle of the servo valve of the oil pump in the central position (until the mixing drum is stationary at this time), operate the throttle handle to open the throttle to 30%, and then operate the handle of the servo valve to make the mixing drum rotate forward at a low speed of 2R / min;
(3)把车开到搅拌站出料漏斗下,使车的进料斗口与搅拌站的出料翻斗对正,避免混凝土流到车外而形成华侈和沾污车体;
(3) Drive the truck under the discharge funnel of the mixing station to align the inlet of the truck with the discharge bucket of the mixing station, so as to prevent the concrete from flowing out of the truck and causing waste and contamination of the car body;
(4)支配伺服阀手柄使搅拌筒正转,转速为4-8r/min,这时候候可向搅拌筒进料;
(4) Operate the handle of the servo valve to make the mixing drum rotate forward, and the rotating speed is 4-8r / min. at this time, the material can be fed into the mixing drum;
打鱼提现app
(5)装推测公称搅动容量时,支配伺服阀手柄和油门手柄使搅拌筒转速为1-3r/min后,把车开至卸料地点,从打金鱼 进推测卸料终了许可的时候不跨越1.5小时;
(5) When the material is loaded to the nominal stirring capacity, operate the servo valve handle and throttle handle to make the mixing drum rotate at 1-3r / min, then drive the truck to the discharging place, and the allowable time from feeding to discharging shall not exceed 1.5h;
(6)车到卸料地点后,把卸料溜槽转向接料地位;
(6) After the truck arrives at the unloading place, turn the unloading chute to the receiving position;
(7)支配伺服阀手柄和油门手柄,使搅拌筒反转,到达8-12r/min遏制卸料;
(7) Operate the servo valve handle and throttle handle to reverse the mixing drum to 8-12r / min for discharging;
(8)运输车可在汽车遏制时卸料,也可在汽车慢速运转中卸料;
(8) The transporter can unload when the vehicle stops or when the vehicle runs slowly;
(9)每次卸料后,必须将进料斗,搅拌筒表里、出料溜槽等洗濯清洁,避免混凝土凝结在上述部件上。
(9) After each discharge, the feeding hopper, the inside and outside of the mixing drum and the discharge chute must be cleaned to prevent the concrete from solidifying on the above parts.
上一篇:打鱼注册送分 手刹查抄查抄事变有哪些?
下一篇: 打鱼注册送分 洗洗更安康!
tag:打鱼注册送分 ,注册送200可提现的打鱼 ,打鱼注册送分200元
以后地位: 首页 - 消息资讯 > 公司消息 >

打金鱼 的宁静支配应当注重甚么?

作者:中科聚峰打鱼注册送分 厂家 时候:2021-05-17

(1)打金鱼 起头任务前,起首策动汽车策念头运转半晌,向贮气筒充气;
(1) Before the mixer starts to work, first start the engine to run for a while and inflate the air reservoir;
(2)把支配油泵伺服阀的手柄放在中间地位(此时搅拌筒处于运动为止),支配油门手柄把油门开到30%的开度,再支配伺服阀手柄,使拌筒在2r/min的低速下正转;
(2) Put the handle of the servo valve of the oil pump in the central position (until the mixing drum is stationary at this time), operate the throttle handle to open the throttle to 30%, and then operate the handle of the servo valve to make the mixing drum rotate forward at a low speed of 2R / min;
(3)把车开到搅拌站出料漏斗下,使车的进料斗口与搅拌站的出料翻斗对正,避免混凝土流到车外而形成华侈和沾污车体;
(3) Drive the truck under the discharge funnel of the mixing station to align the inlet of the truck with the discharge bucket of the mixing station, so as to prevent the concrete from flowing out of the truck and causing waste and contamination of the car body;
(4)支配伺服阀手柄使搅拌筒正转,转速为4-8r/min,这时候候可向搅拌筒进料;
(4) Operate the handle of the servo valve to make the mixing drum rotate forward, and the rotating speed is 4-8r / min. at this time, the material can be fed into the mixing drum;
打鱼提现app
(5)装推测公称搅动容量时,支配伺服阀手柄和油门手柄使搅拌筒转速为1-3r/min后,把车开至卸料地点,从打金鱼 进推测卸料终了许可的时候不跨越1.5小时;
(5) When the material is loaded to the nominal stirring capacity, operate the servo valve handle and throttle handle to make the mixing drum rotate at 1-3r / min, then drive the truck to the discharging place, and the allowable time from feeding to discharging shall not exceed 1.5h;
(6)车到卸料地点后,把卸料溜槽转向接料地位;
(6) After the truck arrives at the unloading place, turn the unloading chute to the receiving position;
(7)支配伺服阀手柄和油门手柄,使搅拌筒反转,到达8-12r/min遏制卸料;
(7) Operate the servo valve handle and throttle handle to reverse the mixing drum to 8-12r / min for discharging;
(8)运输车可在汽车遏制时卸料,也可在汽车慢速运转中卸料;
(8) The transporter can unload when the vehicle stops or when the vehicle runs slowly;
(9)每次卸料后,必须将进料斗,搅拌筒表里、出料溜槽等洗濯清洁,避免混凝土凝结在上述部件上。
(9) After each discharge, the feeding hopper, the inside and outside of the mixing drum and the discharge chute must be cleaned to prevent the concrete from solidifying on the above parts.