1. Before starting the concrete mixing tank truck, a comprehensive inspection must be carried out.
2. 查抄汽车轮胎气压及磨损环境,按划定力矩紧固轮胎螺丝、轮胎气压补充到该车型划定值以内,按照磨损环境遏制轮胎换位。
2. Check the tire pressure and wear condition, tighten the tire screw according to the specified torque, add the tire pressure to the specified value of the vehicle, and transpose the tire according to the wear condition.
3. 查抄发机电、空调、水泵及助力泵皮带的松紧与老化环境。
3. Check the tightness and aging of the belt of generator, air conditioner, water pump and booster pump.
4. 查抄汽车前后车灯是不是齐备(包含:大灯、视宽灯、转向灯、刹车灯、倒车灯及雾灯)。
4. Check whether the front and rear lamps of the car are complete (including: headlamp, width lamp, steering lamp, brake lamp, reversing lamp and fog lamp).
5. 查抄发机电、空调、水泵及助力泵皮带的松紧与老化环境。
5. Check the tightness and aging of the belt of generator, air conditioner, water pump and booster pump.
6. 查抄电瓶液面及玻璃洗濯剂罐的液面。
6. Check the liquid level of the battery and the glass cleaner tank.
7. 查抄转向助力油罐的油面是不是合适划定,查抄体系各油管接口是不是有渗油景象。
7. Check whether the oil level of the power steering oil tank meets the requirements, and check whether there is oil leakage at each oil pipe interface of the system.
8. 查抄制动器及聚散器液面地位。
8. Check the liquid level of brake and clutch.
9. 查抄汽车冷却液液面地位是不是合适划定。
9. Check whether the vehicle coolant level meets the requirements.
10. 做好查抄后，标准行驶打金鱼 。
10. After the inspection, drive the mixer in a standard way.
11. 打鱼注册送分200元 起动策念头后，应使搅拌筒在低速下动弹10分钟摆布，使液压油温升到20℃以上方可任务。
11. After starting the engine of the concrete mixing tank truck, the mixing drum should be turned at low speed for about 10 minutes to make the hydraulic oil temperature rise to above 20 ℃.
12. 打金鱼 装运搅拌好的混凝土时，搅拌筒转速为210转/分，在运输进程中，平展路面上搅拌筒转速保障在2-3转/分，行驶在侧坡度大于50的路面，或摆布晃悠较大的路面时，应遏制搅拌扭转，待路况恶化后再规复搅拌扭转。
12. When the mixer truck transports the mixed concrete, the rotation speed of the mixing drum is 210 rpm. During transportation, the rotation speed of the mixing drum on the flat road should be 2-3 rpm. When driving on the road with side slope greater than 50 or the road with large left and right shaking, the mixing rotation should be stopped, and the mixing rotation should be resumed after the road condition improves.
13. 打鱼注册送分 输送混凝土的时候不能跨越搅拌站划定的时候。输送混凝土途中，搅拌筒不得永劫候停转，以防混凝土发生离析景象。合时常察看混凝土环境，发明非常实时传递调剂室，请求作出处置。
13. The delivery time of concrete by concrete mixer truck shall not exceed the specified time of mixing plant. During the transportation of concrete, the mixing drum shall not stop for a long time to prevent concrete segregation. The concrete condition shall be observed from time to time, and any abnormality found shall be timely reported to the dispatching room for handling.
14. 打金鱼 在排挤混凝土之前，应使搅拌筒在10-12转/分的转速下动弹1分钟，再遏制排料。
14. Before discharging the concrete, the mixer should rotate the mixing drum at the speed of 10-12 rpm for 1 minute before discharging.
15. 打鱼注册送分 出料终了后，应当即用随车的软管放水将进料口、出料斗及出料溜槽等部位冲刷清洁，排去粘结在车身遍地的污物及残留混凝土，再向搅拌筒内灌水150-200L的净水，在前往途中要让搅拌筒慢速动弹，以洗濯内壁，防止剩余料渣附在筒壁和搅拌叶上，并在再一次装料前将这些水放掉。
15. After the discharge of concrete mixer truck, the feeding port, discharge hopper and discharge chute shall be cleaned immediately with the hose attached to the truck, and the dirt and residual concrete bonded to the truck body shall be removed. Then, 150-200l clean water shall be injected into the mixing drum. On the way back, the mixing drum shall rotate slowly to clean the inner wall, so as to avoid the residual slag adhering to the wall and mixing blade, And discharge the water before loading again.