In general, if strong acid and strong alkali are used to corrode, the car tank may be damaged, and the cost is high, requiring a lot of acid and alkali. Now there is a special cleaning industry, with a cost of about 5000. It needs to be hit with an air cannon. One person should go in and clean up the solidified concrete. Therefore, we should pay attention to the cleaning after use and the shutdown time control during use. The more timely the concrete mixing tank is stopped, the easier it is to clean up the concrete.
别的须要注重的是，碰到这类环境，车损险是不予赔付的。按照车险划定：因本身运载货色或则车内物体活动碰撞致使本车车损，属义务免去规模。按照保险的远因准绳，致使罐体丧失的间接缘由罐体停转、水泥凝结，而非不测变乱致使罐体丧失，以是是不予赔付的 。
In addition, it should be noted that in this case, the vehicle damage insurance will not be compensated. According to the provisions of vehicle insurance: the damage of the vehicle caused by the movement and collision of its own goods or objects in the vehicle belongs to the scope of liability exemption. According to the principle of proximate cause of insurance, the direct cause of tank loss is tank shutdown and cement solidification, rather than tank loss caused by accident, so it is not compensated.
也便是说若是遭受罐体停转而混凝土凝结所受丧失，是没法请求保险公司赔付的。
In other words, if the tank stops and the concrete solidifies, the insurance company cannot be required to compensate.
打鱼注册送分
在功课进程中若是液压体系产生毛病，而恰好四周也不能够利用的高压油管及济急的打金鱼
，那末时候一长搅拌筒里的混凝土就会凝结在罐体内，一但混凝土凝结那末罐体根基上就算报废了。
If the hydraulic system of the concrete mixer fails during operation, and there is no high-pressure oil pipe and emergency mixer nearby, the concrete in the mixing drum will solidify in the tank over time. Once the concrete solidifies, the tank will basically be scrapped.
那末是不是不一点盘旋的余地呢，世事无相对。当打鱼注册送分
赶上这类特别环境时，若是不想改换罐体，能够请的清算职员对罐体停止破拆功课，其体例是将罐体用氧焊切割一个可供一个进入的大洞，而后用破拆机器，一点点停止破拆，职员进入罐体内一点点的停止破拆，直到混凝土清算清洁。把罐体切割口用电焊封锁。
So is there no room for maneuver? There is no absolute in the world. When the concrete mixer meets this special situation, if you don't want to replace the tank, you can ask professional cleaning personnel to break and dismantle the tank. The method is to cut a large hole for one access with oxygen welding, then use the breaking and dismantling machinery to break and dismantle it bit by bit, and finally enter the tank to break and dismantle it bit by bit until the concrete is cleaned. Finally, seal the cutting opening of the tank body with electric welding.
Thank you for reading. Source of this article: automatic concrete mixer. For more contents and questions, please click: http://zhaoyanfilter.com We will continue to work hard to provide you with services. Thank you for your support!