1. After daily operation, it is the driver's responsibility to pour clean water into the mixing tank and rotate it at high speed (14-18 RPM) for 5-10 minutes, and then drain the water to ensure that the drum is clean. When cleaning all parts of the mixing drum with high-pressure water, care should be taken to avoid using parts such as appearance and operating lever. The distance between the pressure water nozzle and the exterior of body paint shall not be less than 40 cm.
2.在施工现场卸货后，应利用主动上料的打金鱼 随附的软管冲刷料斗，料斗，卸料斜槽等，以断根附着在车身上的污泥和混凝土。在前往搅拌站的途中，应将150-200 L的水注入搅拌罐，以撤除粘附在搅拌罐壁和叶片上的混凝土残渣。液压体系的压力应合适利用申明书中的划定，不能随便调理。液压油的品质和数目应合适原始请求。
2. After unloading at the construction site, the hose attached to the automatic loading mixer should be used to flush the hopper, hopper, discharge chute, etc. to remove the sludge and concrete attached to the vehicle body. On the way back to the mixing plant, 150-200 l of water shall be injected into the mixing tank to remove the concrete residue adhering to the tank wall and blades. The pressure of the hydraulic system should be in accordance with the provisions of the operation manual, and can not be adjusted at will. The quality and quantity of hydraulic oil shall meet the original requirements.
3.在夏季施工中，应做以下任务：起头前查抄是不是结冰；放工后，细心洁净夹杂罐和供水体系中的残留水，封闭泵的开关，并将节制手柄置于“遏制”地位。
3. In winter construction, the following work should be done: check whether there is icing before starting; after work, carefully clean the residual water in the mixing tank and water supply system, turn off the pump switch, and put the control handle in the "stop" position.
4.领会主动上料的打金鱼 的布局，任务道理和操纵方式。
4. Understand the structure, working principle and operation method of automatic feeding mixer.
主动上料的打金鱼 洁净功课对机能是很重的。
The cleaning operation of automatic feeding mixer is very important for performance.