1. After softening, it is recommended to use soft water and hard water to prevent blockage and scaling in the radiator.
2.装置散热器时，请注重不要破坏散热器（片）和保险杠散热器，以确保散热和密封。
2. When installing the radiator, please pay attention not to damage the radiator (fin) and bumper radiator to ensure heat dissipation and sealing.
3.利用防冻剂时，请务必利用受权制作商出产的持久防冻剂/防冻剂，并遵照国度规范，以防止散热器侵蚀。
3. When using antifreeze, be sure to use the long-term antifreeze / antifreeze produced by the authorized manufacturer, and comply with the national standard to prevent the radiator from corrosion.
4.备用散热器的有用环境应坚持透风杰出并枯燥。
4. The effective environment of spare radiator should be well ventilated and dry.
5.对平常利用，请随时查抄水位并在冷却后遏制放水。加水时，渐渐翻开水箱盖。使操纵职员的身材尽能够阔别进水口，以防止高压蒸汽放射形成烫伤。
5. For daily use, please check the water level at any time and stop draining after cooling. When adding water, slowly open the tank cover. Keep the operator's body as far away from the water inlet as possible to prevent scalding caused by high-pressure steam injection.
6.主动打鱼注册送分 的散热器不得与酸，碱或其余侵蚀性物资打仗。
6. The radiator of automatic concrete mixer shall not contact with acid, alkali or other corrosive substances.
7.水位表应每3个月或按照现实环境遏制洁净。须要取下整机，并用温水和非侵蚀性洁净剂洗濯。
7. The water level gauge should be cleaned every three months or according to the actual situation. Parts need to be removed and cleaned with warm water and non corrosive detergent.
8.在夏季，应利用水箱盖和排水开关排挤一切水，以防止岩心因为持久泊车或直接泊车等解冻而解冻。
8. In winter, water tank cover and drain switch should be used to drain all water to prevent core freezing due to long-term or indirect shutdown.
9.按照现实环境，用户能够须要完整洁净散热器1-3个月。洁净时，请沿着反向进气口的正面用水冲刷。
9. According to the actual situation, users may need to thoroughly clean the radiator for 1-3 months. When cleaning, rinse with water along the side of the reverse air inlet.
10.散热器完整排空偏重新注满后，起首封闭策念头缸体上的排水开关。当水流出时，请再次将其封闭以防止起泡。
10. After the radiator is completely drained and refilled, first turn off the drain switch on the engine block. When water flows out, turn it off again to prevent foaming.