The mixing quality of Zhongke Jufeng concrete mixer is closely related to mixing time besides raw materials and equipment. The mixing time of concrete mixer refers to the time from the completion of filling to the beginning of discharging, which can be determined according to the slump of mixing materials and the capacity of concrete mixer. Be sure to stir well.
通俗混凝土搅拌机的搅拌时候为1-2分钟。用“净石法”搅拌约3分钟。混凝土搅拌机的搅拌时候较短。比方，JD200混凝土搅拌机能够或许或许或许利用30秒。能够或许或许或许。简而言之，它能够或许或许或许按照布局的现实环境经由进程尝试来肯定。坍落度(机器捣固1-2 cm，手动捣固2-4 cm)。与细砂混凝土夹杂可按照现实环境耽误搅拌时候。
Generally, the mixing time of concrete mixer is 1-2 minutes. Stir with "clean stone method" for about 3 minutes. The mixing time of concrete mixer is short. For example, the jd200 concrete mixer can be used for 30 seconds. Can. In short, it can be determined by experiments according to the actual situation of the structure. Slump (mechanical tamping 1-2cm, manual tamping 2-4cm). Mixing with fine sand concrete can prolong the mixing time according to the actual situation.
混凝土搅拌叶片的装置:混凝土搅拌叶片的角度应不异，不可反转。若是搅拌叶片的倾斜角过大或太小，城市影响搅拌的制品率，以是叶片与搅拌轴的倾斜角能够或许或许或许在70度或80度摆布。搅拌叶片的首选角度扭转到上部，显露20-30mm的泥浆。两个轴上的夹杂叶片的相位应与油漆的相位偏移90度;装置搅拌刀片时，应拧紧。拧紧搅拌叶片上的螺母。
Installation of concrete mixing blades: the angle of concrete mixing blades shall be the same and shall not be reversed. If the tilt angle of the mixing blade is too large or too small, it will affect the mixing yield, so the tilt angle between the blade and the mixing shaft can be about 70 or 80 degrees. The preferred angle of the mixing blade is rotated to the upper part, exposing 20-30mm of mud. The phase of the mixing blades on both shafts shall be offset by 90 degrees from the phase of the paint; when installing the mixing blades, they shall be tightened. Tighten the nut on the mixing blade.
混凝土搅拌机叶片毁伤的首要缘由是叶片磨损。此时，切割炬须要切割刀片的边缘停止磨损，而后用刀片厚度不异的钢板切割成所需的尺寸;叶柄曲折。或断裂，两种环境的缘由是:叶柄不够健壮，而后增添叶柄的直径，并利用圆钢;叶柄资料易碎，可改成通俗圆钢。
The main cause of blade damage of concrete mixer is blade wear. At this time, the cutting torch needs to cut the edge of the blade for wear, and then use the steel plate with the same thickness of the blade to cut into the required size; the petiole is bent. Or fracture, two reasons are: the petiole is not strong enough, then increase the diameter of the petiole, and use round steel; the petiole material is fragile, and can be changed to ordinary round steel.
以上是中科聚峰混凝土搅拌机厂家为大师先容的相干内容，想要领会更多内容，接待拜候网站：The above is the relevant content introduced by the manufacturer of Zhongke Jufeng concrete mixer. To learn more, please visit the website: