The upper electrical system of the mixer consists of three parts: the electric control device of the water supply system (electric water pump control part, pneumatic water supply system electric control alarm device), the cooling fan control part and the rear clearance lamp, side marker lamp and work lamp.
1）供水体系电控装配
1) Electric control device of water supply system
①电动水泵节制局部 电动水泵操纵开关位于车后部右边开关盒上，在电动水泵任务前应先确保策念头运行、水箱有水、水管阀门翻开。水箱水用完时应关停水泵，严禁无水空转电动水泵，以避免破坏电动水泵。电 动水泵任务时开关盒内蜂鸣器鸣叫，起警示功课。
① The electric water pump operation switch of the electric water pump control part is located on the right switch box at the rear of the vehicle. Before the electric water pump works, ensure that the engine runs, the water tank has water and the water pipe valve is opened. When the water tank is used up, the water pump shall be shut down. It is strictly prohibited to idle the electric water pump without water to avoid damaging the electric water pump. When the electric water pump is working, the buzzer in the switch box will sound for warning operation.
②气压式供水体系电控报警装配 翻开驾驶室内原水泵开关，气压式供水体系蜂鸣节制器继电器得电，蜂鸣器鸣叫，同时电磁气阀接通，气源从储气筒经电磁阀进入喷水压力水罐，翻开喷水阀遏制喷水洗车功课，喷水洗车终了后蜂鸣器仍在鸣叫，提示操纵者封闭水泵开关。
② The electric control alarm device of the pneumatic water supply system turns on the raw water pump switch in the cab, the buzzer of the pneumatic water supply system buzzes, the relay of the controller is powered on, the buzzer buzzes, and the solenoid valve is connected. The air source enters the water spray pressure water tank from the air reservoir through the solenoid valve, and the water spray valve is opened for water spray car washing. After water spray car washing, the buzzer still buzzes, Remind the operator to turn off the water pump switch.
2）冷却电扇节制局部
2) Cooling fan control section
冷却电扇的启停由温控开关主动节制，温度高于65℃时电扇启动，低于60℃时电扇遏制。温控开关位于冷却器上，继电器与保险片在驾驶室内配电盒内。
The start and stop of the cooling fan is automatically controlled by the temperature control switch. The fan starts when the temperature is higher than 65 ℃ and stops when the temperature is lower than 60 ℃. The temperature control switch is located on the cooler, and the relay and fuse are in the power distribution box in the cab.
3）后示廓灯、侧标记灯、任务灯局部 后示廓灯、侧标记灯用于夜间表现车后部表面巨细、正面表面，与后派司灯同时点亮、燃烧。任务灯用于夜间进料与卸料照明，开关在驾驶室内。
3) Rear clearance lamp, side marker lamp, work lamp part rear clearance lamp and side marker lamp are used to indicate the size and side contour of the rear of the vehicle at night, and turn on and off at the same time as the rear license plate lamp. The working light is used for night feeding and unloading lighting, and the switch is in the cab.
本文由注册送200可提现的打鱼 友谊贡献.更多有关的常识请点击:http://zhaoyanfilter.com朴拙的立场.为您供给为周全的办事.更多有关的常识咱们将会连续向大师贡献.敬请等候.
This article is dedicated by small concrete mixer truck. For more information, please click: http://zhaoyanfilter.com Sincere attitude. To provide you with a comprehensive service. More relevant knowledge, we will continue to offer to you. Please look forward to it